There are many varieties of waste compaction equipment. There are large refuse, heavy duty, low emissions, drum and stationary compactors. These can have varying engine, holding and pushing capacities. Conveyors of different inclines, constructions and textures are also available.
Large refuse compactors may be fitted with a tooth type design. These teeth come as one piece and are made of materials that are very strong and resistant to wear. Some models have a 536-hp and the capacity to lift as much as 120,000 pounds. Further, they may be equipped with a 17 foot blade for leveling and can push with a force of 99,000 pounds. Usually these compactors are controlled with an electronic joystick steering mechanism. Load-sensing technology is optional and assists in steering and control of the blade.
Heavy duty compactors are designed for heavy industrial use. They may weigh 11,500 pounds and operate at a pressure of 2400 psi. Its electric motors have a 30-hp. Some models can achieve a 92,300 pound ram force and a 32 second cycle time. Its pump can handle around 63 gallons a minute and the tank capacity reaches 180 gallons.
Drum compactors compact waste considered hazardous or low-level between 55 or 85 gallon drums. Most units achieve a force from 20,000 up to 85,000 pounds. This high efficiency reduces typical disposal costs by up equipment for weighing to ninety percent. Some 55 gallon drums are crushed into three to seven inch thick shapes. This great reduction in volume lowers costs of disposal. Also, it prevents any contaminated containers from being reused.
Low emissions landfill compactors are available. These have modified engines to produce fewer emissions and an increased efficiency cooling system. Engines normally have around 498 net hp at 1800 rpm. The machine runs quietly and produces minimal pollutants. Blades may be programmed to lower automatically when the machine shifts forwards or raises in reverse. This helps further improve efficiency.
Stationary compactors vary in size from one third of a cubic yard to ten cubic yards. The waste is deposited into a large opening, around eighty by one hundred and twenty inches. The large size of industrial machinery columbus ohio this opening allows for exceptionally bulky refuse to be processed. The trash is compacted and stored in containers or transfer trailers. These are then picked up and brought to a disposal site.
Conveyors are available to assist processing waste. These come in many forms and have many unique features. They can be made of stainless steel or carbon. They can be intended for horizontal or inclined positioning, or with a combination of alternative settings. Belts can be made of rubber or of PVC and can be flat or cleated. There are conveyors that are portable and conveyors that are meant for stationary use.
Waste compaction equipment can be purchased in a wide variety. Compactors are created for processing large or heavy refuse. Certain models are designed specifically to handle hazardous wastes. Others are meant to remain stationary instead of maneuvered around with the help of a joy stick. Low emissions models take pollution and efficiency into account. Conveyors are also available in many forms to help with the tasks associated with processing compacted waste.
